Sprinkler repair
Diagnose leaks, timer issues, and broken lines. We find the cause, show you what failed, and price the fix before work starts.
Learn moreService
Fix broken, stuck, or misaligned sprinkler heads. We clean, adjust, or reseal what can be saved and tell you when a head needs replacing.
North Dallas Sprinkler Repair handles sprinkler head repair in Plano, TX for homeowners dealing with broken, stuck, or misaligned heads. We clean, adjust, or reseal heads that can be saved, and we tell you straight when a head needs replacing instead. You get a working system, an even spray pattern, and a plain explanation of what was wrong and what the fix cost covers.
Sprinkler heads take a beating in Plano. Mowers clip them, clay soil shifts around them, and hard water clogs them. Here is the work we handle:
If the problem runs deeper than the head, such as a valve that will not shut off or a cut line, we handle that too. Sprinkler valve replacement and full sprinkler repair are part of what we do.
We start by running each zone and watching how it performs. A head that sputters, leaks, or stays down tells a different story than one that sprays the fence. We check pressure, coverage, and the condition of each head in the problem zone.
Before we dig or swap anything, we walk you through what we found. If a head can be cleaned, adjusted, or resealed, that is the fix we recommend. If the head is cracked or worn past saving, we say so and explain what sprinkler head replacement involves instead.
We dig carefully around the head, since Plano's clay soil hides lines and wiring close to the surface. We clean or repair what can be saved, replace what cannot, and match new parts to the heads already on that zone so coverage stays even.
After the repair, we run the zone again. We confirm every head pops up, retracts, and covers its area without overspray. Before we leave, we can also talk through your watering schedule so it fits Plano's watering restrictions and the long summer heat.
No two repairs cost the same, but the factors are simple:
Questions about sprinkler system repair cost are fair, and the honest answer depends on what we find when we run your zones. Reach out and we will give you a concrete quote for your yard, not a guess.
North Dallas Sprinkler Repair fixes and tunes up lawn sprinkler and irrigation systems for Plano homeowners who want reliable watering without the guesswork. We explain the problem, the fix, and the cost factors in plain terms, so you know what you are paying for before the work starts.
We work from Plano's actual conditions. North Texas clay soil shifts and cracks irrigation lines. Long, hot summers and local watering restrictions shape when and how long your system should run. Freeze events damage backflow preventers and valves. We factor all of that into every repair, not just the head in front of us.
Beyond sprinkler head repair, we handle sprinkler head replacement, sprinkler valve replacement, sprinkler system installation, and French drain installation. We serve Plano and nearby North Dallas communities including Richardson, Allen, Frisco, McKinney, Murphy, Wylie, Garland, Carrollton, Addison, The Colony, Lewisville, Flower Mound, Irving, Rowlett, Denton, and Celina.
A sprinkler head that stays up after the cycle usually has dirt or debris jamming the stem, or a worn retraction spring. Cleaning the head and flushing the grit often solves it. If the seal is worn out, the head needs resealing or replacing.
Yes, in most cases. The head itself usually needs replacing, but the fitting below it often survives. We dig out the broken piece, inspect the riser and fitting, and install a new head that matches the rest of the zone.
A straight column of water means the nozzle is missing, cracked, or blown off. This wastes water fast and leaves dry spots nearby. The fix is a new nozzle sized and set for that zone's coverage.
Repair it if the body and seal are in good shape and the problem is dirt or a clog. Replace it if the body is cracked, the seal leaks, or the head is old enough that parts keep failing. We check the head first and recommend the cheaper fix when it will actually hold.
Turn the system off at the controller first, and if water keeps flowing, close the shutoff valve on the irrigation line, often near the backflow preventer. That stops the water loss until the repair. If you cannot find the shutoff, call us and we will walk you through it.
It should, and that is part of the job. We match the head type, spray pattern, and precipitation rate to the other heads on the zone. Mismatched heads cause wet spots and dry spots even when everything works.
If a head is stuck, broken, or spraying the wrong way, request a quote and tell us what you are seeing. We will run your zones, show you what is wrong, and give you a clear price before any work begins. A broken head wastes water every cycle, so the sooner it is fixed, the less you pay the water bill for nothing.
Prefer to talk it through? Call (469) 639-1022 — a quick call is usually the fastest way to get a straight answer for your situation.
Where we work
Need sprinkler head repair? We're ready to help.
We fix broken heads, valves, and leaks. Call for a diagnosis and an upfront estimate before any work starts.
Related
Diagnose leaks, timer issues, and broken lines. We find the cause, show you what failed, and price the fix before work starts.
Learn moreSwap broken or outdated sprinkler heads for efficient modern ones matched to each zone, so coverage is even and water is not wasted.
Learn moreReplace failed solenoid valves and main shutoffs. Stuck or leaking valves waste water and money fast.
Learn moreDesign and install full systems from scratch. Zones, controller, heads, and valves sized for your yard.
Learn moreInstall subsurface drainage to move standing water and pooling. Protects foundations and prevents lawn damage.
Learn more